0
RESEARCH PAPERS

Sublimation Mass Transfer Through Compressible Boundary Layers on a Flat Plate

[+] Author and Article Information
T. K. Sherwood

Massachusetts Institute of Technology, Cambridge, Mass.

Olev Träss

University of Toronto, Toronto, Ont., Canada

J. Heat Transfer 82(4), 313-324 (Nov 01, 1960) (12 pages) doi:10.1115/1.3679941 History: Received August 21, 1959

Abstract

Data are reported on rates of sublimation mass transfer from an adiabatic, sharp-edged flat plate exposed to air streams at Mach numbers of 0.43, 2.0, and 3.5. Thickness decrease of the subliming naphthalene coating, plate surface temperature, and flow conditions were measured. An analysis of friction and heat transfer in turbulent compressible flow has been extended to mass transfer at low rates. Agreement between theory and data is good over the entire range of Reynolds numbers from 3 × 104 to 9 × 106 . The effect of compressibility on mass transfer is found to be slightly greater than on friction. The measurement of the sublimation rate of thin coatings of solids provides a powerful technique of obtaining local friction coefficients, being simpler and of a wider applicability than the method involving force measurements on small floating surface elements.

Copyright © 1960 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In