Effect of Adiabatic Co-Planar Extension Surfaces on Wind-Related Solar-Collector Heat Transfer Coefficients

[+] Author and Article Information
E. M. Sparrow, S. C. Lau

Department of Mechanical Engineering, University of Minnesota, Minneapolis, Minn. 55455

J. Heat Transfer 103(2), 268-271 (May 01, 1981) (4 pages) doi:10.1115/1.3244452 History: Received September 17, 1980; Online October 20, 2009


The heat transfer response to framing the thermally active cover surface of a flat plate solar collector with adiabatic co-planar extension surfaces has been investigated by wind tunnel experiments. Various framing patterns were employed (leading edge and/or trailing edge and/or side edge framing), along with frames of different width. The experiments were performed for various angles of inclination of the plate surface relative to the oncoming airstream and for a range of Reynolds numbers. It was found that the wind-related heat transfer coefficients can be substantially lower when the collector is framed than when it is unframed. An estimate of the possible reduction of the average heat transfer coefficient can be obtained from the equation h/h* = (Lc /Lf )1/2 , where h and h* respectively denote the coefficients in the presence and in the absence of the frame. The quantity Lc is a dimension that is characteristic of the thermally active area of the cover surface, while Lf is a characteristic dimension of the outer edges of the frame. With respect to the reduction of the heat transfer coefficient, framing along the side edges appears to be more beneficial than framing along the leading and trailing edges, as is framing along the trailing edge compared with framing along the leading edge.

Copyright © 1981 by ASME
Your Session has timed out. Please sign back in to continue.






Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In