RESEARCH PAPERS: Forced Convection

The Centerline Pressure and Cavity Shape of Horizontal Plane Choked Vapor Jets With Low Condensation Potential

[+] Author and Article Information
T. J. Eden, T. F. Miller

Applied Research Laboratory, The Pennsylvania State University, P. O. Box 30, State College, PA 16804

H. R. Jacobs

College of Engineering, Colorado State University, Fort Collins, CO 80523

J. Heat Transfer 120(4), 999-1007 (Nov 01, 1998) (9 pages) doi:10.1115/1.2825921 History: Received June 23, 1997; Revised May 20, 1998; Online December 05, 2007


A study of plane, underexpanded, condensing vapor jets was undertaken using flash photography and a ventilated pressure probe. This study examined horizontal jets with much lower condensation driving potentials than have been previously studied. Photographic measurements of jet expansion angles, spread angles, cavity lengths, and cavity shapes were recorded and compared with numerical predictions using a parabolic, locally homogeneous flow model that had been modified to incorporate entrainment and condensation effects. When rendered dimensionless by the nozzle width rather than diameter, the plane condensation length agreed well with previously published round jet correlations for higher condensation driving potentials. At lower condensation driving potentials, the jets began to disperse, showing behavior similar to submerged air and energetic reacting vapor jets. Numerical predictions of condensation length were in good agreement over the entire range of measurement. Numerical predictions of vapor cavity shape were in reasonable agreement at higher condensation potentials but underpredicted the width of the vapor cavity at lower potentials. Pressure measurements showed the existence of periodic expansion/compression cells associated with underexpanded noncondensing gas jets. When these measurements were compared with similar measurements of air jets into quiescent water baths, the lengths of the initial steam vapor expansion/compression cells were substantially greater than those of the air jets, and the degree of pressure recovery over the cell length was substantially less.

Copyright © 1998 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.





Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In