Research Papers: Evaporation, Boiling, and Condensation

Combined Dielectrophoretic and Electrohydrodynamic Conduction Pumping for Enhancement of Liquid Film Flow Boiling

[+] Author and Article Information
Viral K. Patel

Multi Scale Heat Transfer Laboratory,
Department of Mechanical Engineering,
Worcester Polytechnic Institute,
Worcester, MA 01609
e-mail: vkpatel@wpi.edu

Jamal Seyed-Yagoobi

Multi Scale Heat Transfer Laboratory,
Department of Mechanical Engineering,
Worcester Polytechnic Institute,
Worcester, MA 01609
e-mail: jyagoobi@wpi.edu

Contributed by the Heat Transfer Division of ASME for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received December 13, 2015; final manuscript received January 2, 2017; published online February 28, 2017. Assoc. Editor: Debjyoti Banerjee.

J. Heat Transfer 139(6), 061502 (Feb 28, 2017) (9 pages) Paper No: HT-15-1786; doi: 10.1115/1.4035709 History: Received December 13, 2015; Revised January 02, 2017

This paper extends previous liquid film flow boiling studies by including the effect of an additional electrohydrodynamic (EHD) force, namely, the dielectrophoretic (DEP) force. Rather than using only EHD conduction pumping of the liquid film to electro-wet the heater surface, a localized nonuniform electric field above the heater surface is established to generate a DEP force for improved vapor bubble extraction during the nucleate boiling regime. The effects of liquid film height and applied potential are studied as a function of heater superheat and heat flux. A brief analytical study is also used to estimate the expected DEP force magnitude to explain the results. All of the above studies are also used to quantify the enhancement in heat transfer that can be achieved when heat transport systems are driven or augmented by these two EHD mechanisms. The results show remarkable enhancement of up to 1217% in boiling heat transfer coefficient at a given superheat when both mechanisms are used simultaneously. The experimental data are important for applications in thermal management in terrestrial and space conditions.

Copyright © 2017 by ASME
Your Session has timed out. Please sign back in to continue.


Melcher, J. R. , 1981, Continuum Electromechanics, MIT Press, Cambridge, MA.
Atten, P. , and Seyed-Yagoobi, J. , 2003, “ Electrohydrodynamically Induced Dielectric Liquid Flow Through Pure Conduction in Point/Plane Geometry,” IEEE Trans. Dielectr. Electr. Insul., 10(1), pp. 27–36. [CrossRef]
Pearson, M. R. , and Seyed-Yagoobi, J. , 2015, “ Experimental Study of Linear and Radial Two-Phase Heat Transport Devices Driven by Electrohydrodynamic Conduction Pumping,” ASME J. Heat Transfer, 137(2), p. 022901. [CrossRef]
Patel, V. K. , Seyed-Yagoobi, J. , Sinha-Ray, S. , Sinha-Ray, S. , and Yarin, A. , 2016, “ Electrohydrodynamic Conduction Pumping Driven Liquid Film Flow Boiling on Bare and Nanofiber-Enhanced Surfaces,” ASME J. Heat Transfer 138(4), p. 041501.
Patel, V. K. , Seyed-Yagoobi, J. , Robinson, F. , and Didion, J. R. , 2016, “ Effect of Gravity on Electrohydrodynamic Conduction Driven Liquid Film Flow Boiling,” AIAA J. Thermophys. Heat Transfer, 30(2), pp. 429–437. [CrossRef]
Yazdani, M. , and Seyed-Yagoobi, J. , 2009, “ Electrically Induced Dielectric Liquid Film Flow Based on Electric Conduction Phenomenon,” IEEE Trans. Dielectr. Electr. Insul., 16(3), pp. 768–777. [CrossRef]
Yazdani, M. , and Seyed-Yagoobi, J. , 2008, “ Numerical Investigation of Electrohydrodynamic-Conduction Pumping of Liquid Film in the Presence of Evaporation,” ASME J. Heat Transfer, 131(1), p. 011602. [CrossRef]
Pohl, H. A. , 1978, Dielectrophoresis: The Behavior of Neutral Matter in Nonuniform Electric Fields, Cambridge University Press, Cambridge, UK.
Jones, T. B. , and Bliss, G. W. , 1977, “ Bubble Dielectrophoresis,” J. Appl. Phys., 48(4), pp. 1412–1417. [CrossRef]
Pearson, M. R. , and Seyed-Yagoobi, J. , 2008, “ Numerical Study of Dielectric Fluid Bubble Behavior Within Diverging External Electric Fields,” ASME J. Heat Transfer, 130(3), p. 032901. [CrossRef]
Ogata, J. , and Yabe, A. , 1993, “ Augmentation of Boiling Heat Transfer by Utilizing the EHD Effect—EHD Behaviour of Boiling Bubbles and Heat Transfer Characteristics,” Int. J. Heat Mass Transfer, 36(3), pp. 783–791. [CrossRef]
Seyed-Yagoobi, J. , Geppert, C. A. , and Geppert, L. M. , 1996, “ Electrohydrodynamically Enhanced Heat Transfer in Pool Boiling,” ASME J. Heat Transfer, 118(1), p. 233. [CrossRef]
Seyed-Yagoobi, J. , Hardesty, J. T. , Raghupathi, P. , and Bryan, J. E. , 1997, “ Experimental Study of Electrohydrodynamically Augmented Pool Boiling Heat Transfer on Smooth and Enhanced Tubes,” J. Electrost., 40–41, pp. 597–602. [CrossRef]
Darabi, J. , Ohadi, M. M. , and Dessiatoun, S. V. , 1999, “ Augmentation of Thin Falling-Film Evaporation on Horizontal Tubes Using an Applied Electric Field,” ASME J. Heat Transfer, 122(2), pp. 391–398. [CrossRef]
Kweon, Y. C. , and Kim, M. H. , 2000, “ Experimental Study on Nucleate Boiling Enhancement and Bubble Dynamic Behavior in Saturated Pool Boiling Using a Nonuniform DC Electric Field,” Int. J. Multiphase Flow, 26(8), pp. 1351–1368. [CrossRef]
Hristov, Y. , Zhao, D. , Kenning, D. B. R. , Sefiane, K. , and Karayiannis, T. G. , 2009, “ A Study of Nucleate Boiling and Critical Heat Flux With EHD Enhancement,” Heat Mass Transfer, 45(7), pp. 999–1017. [CrossRef]
Kano, I. , and Takahashi, Y. , 2013, “ Effect of Electric Field Generated by Microsized Electrode on Pool Boiling,” IEEE Trans. Ind. Appl., 49(6), pp. 2382–2387. [CrossRef]
Kano, I. , Higuchi, Y. , and Chika, T. , 2013, “ Development of Boiling Type Cooling System Using Electrohydrodynamics Effect,” ASME J. Heat Transfer, 135(9), p. 091301. [CrossRef]
DuPont, 2005, “ Thermodynamic Properties of HCFC-123 Refrigerant,” DuPont Fluorochemicals, Wilmington, DE.
Bryan, J. E. , 1998, “ Fundamental Study of Electrohydrodynamically Enhanced Convective and Nucleate Boiling Heat Transfer,” Ph.D. thesis, Texas A&M University, College Station, TX.
Siddiqui, M. , and Seyed-Yagoobi, J. , 2009, “ Experimental Study of Pumping of Liquid Film With Electric Conduction Phenomenon,” IEEE Trans. Ind. Appl., 45(1), pp. 3–9. [CrossRef]
Zuber, N. , 1959, “ Hydrodynamic Aspects of Boiling Heat Transfer,” U.S. AEC, Washington, DC, Technical Report No. AECU-4439.
Rohsenow, W. M. , 1952, “ Method of Correlating Heat-Transfer Data for Surface Boiling of Liquids,” ASME Trans., 74(6), pp. 969–975.
Jabardo, J. M. S. , Silva, E. F. D. , Ribatski, G. , and Barros, S. F. D. , 2004, “ Evaluation of the Rohsenow Correlation Through Experimental Pool Boiling of Halocarbon Refrigerants on Cylindrical Surfaces,” J. Braz. Soc. Mech. Sci. Eng., 26(2), pp. 218–230. [CrossRef]


Grahic Jump Location
Fig. 1

Concept of liquid film flow boiling with combined EHD conduction and DEP force

Grahic Jump Location
Fig. 2

Schematic showing electrode dimensions and spacing between electrode pairs (only ¼ of the full circle is illustrated)

Grahic Jump Location
Fig. 3

Stainless steel DEP electrode design

Grahic Jump Location
Fig. 8

Low heat flux data for all the cases from Fig. 7 (excluding correlation predictions)

Grahic Jump Location
Fig. 7

Experimental data and correlation prediction for combined EHD-pumping and DEP-enhanced liquid film flow boiling/pool boiling

Grahic Jump Location
Fig. 6

DEP electrode installed in liquid film flow boiling experiment

Grahic Jump Location
Fig. 5

Cross section of experiment housing showing two chambers separated by interface plate

Grahic Jump Location
Fig. 4

Heater assembly showing copper heater piece installed in Delrin insulator

Grahic Jump Location
Fig. 9

Heater/DEP electrode geometry

Grahic Jump Location
Fig. 10

Four x-locations for electric field calculations

Grahic Jump Location
Fig. 11

Square of electric field magnitude along y-axis at various x-locations

Grahic Jump Location
Fig. 12

Estimation of DEP force magnitude along y-axis at various x-locations versus buoyancy force for 0.5 mm bubble diameter




Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In