An experimental study was conducted to characterize the transient behavior of laminar flow separation on a NASA low-speed GA (W)-1 airfoil at the chord Reynolds number of 70,000. In addition to measuring the surface pressure distribution around the airfoil, a high-resolution particle image velocimetry (PIV) system was used to make detailed flow field measurements to quantify the evolution of unsteady flow structures around the airfoil at various angles of attack (AOAs). The surface pressure and PIV measurements clearly revealed that the laminar boundary layer would separate from the airfoil surface, as the adverse pressure gradient over the airfoil upper surface became severe at . The separated laminar boundary layer was found to rapidly transit to turbulence by generating unsteady Kelvin–Helmholtz vortex structures. After turbulence transition, the separated boundary layer was found to reattach to the airfoil surface as a turbulent boundary layer when the adverse pressure gradient was adequate at , resulting in the formation of a laminar separation bubble on the airfoil. The turbulence transition process of the separated laminar boundary layer was found to be accompanied by a significant increase of Reynolds stress in the flow field. The reattached turbulent boundary layer was much more energetic, thus more capable of advancing against an adverse pressure gradient without flow separation, compared to the laminar boundary layer upstream of the laminar separation bubble. The laminar separation bubble formed on the airfoil upper surface was found to move upstream, approaching the airfoil leading edge as the AOA increased. While the total length of the laminar separation bubble was found to be almost unchanged ( of the airfoil chord length), the laminar portion of the separation bubble was found to be slightly stretched, and the turbulent portion became slightly shorter with the increasing AOA. After the formation of the separation bubble on the airfoil, the increase rate of the airfoil lift coefficient was found to considerably degrade, and the airfoil drag coefficient increased much faster with increasing AOA. The separation bubble was found to burst suddenly, causing airfoil stall, when the adverse pressure gradient became too significant at .
Skip Nav Destination
e-mail: huhui@iastate.edu
Article navigation
May 2008
Research Papers
An Experimental Study of the Laminar Flow Separation on a Low-Reynolds-Number Airfoil
Hui Hu,
Hui Hu
Assistant Professor
Department of Aerospace Engineering,
e-mail: huhui@iastate.edu
Iowa State University
, Ames, IA 50011
Search for other works by this author on:
Zifeng Yang
Zifeng Yang
Graduate Student
Department of Aerospace Engineering,
Iowa State University
, Ames, IA 50011
Search for other works by this author on:
Hui Hu
Assistant Professor
Department of Aerospace Engineering,
Iowa State University
, Ames, IA 50011e-mail: huhui@iastate.edu
Zifeng Yang
Graduate Student
Department of Aerospace Engineering,
Iowa State University
, Ames, IA 50011J. Fluids Eng. May 2008, 130(5): 051101 (11 pages)
Published Online: April 25, 2008
Article history
Received:
April 7, 2007
Revised:
January 31, 2008
Published:
April 25, 2008
Citation
Hu, H., and Yang, Z. (April 25, 2008). "An Experimental Study of the Laminar Flow Separation on a Low-Reynolds-Number Airfoil." ASME. J. Fluids Eng. May 2008; 130(5): 051101. https://doi.org/10.1115/1.2907416
Download citation file:
Get Email Alerts
Effects of Tire Attributes on the Aerodynamic Performance of a Generic Car–Tire Assembly
J. Fluids Eng (January 2025)
Related Articles
Bubble-Induced Unsteadiness on A Wind Turbine Airfoil
J. Sol. Energy Eng (November,2002)
Passive Manipulation of Separation-Bubble Transition Using Surface Modifications
J. Fluids Eng (February,2009)
Transition Mechanisms in Separation Bubbles Under Low- and Elevated-Freestream Turbulence
J. Turbomach (January,2010)
Separation Control on a Very High Lift Low Pressure Turbine Airfoil Using Pulsed Vortex Generator Jets
J. Turbomach (October,2011)
Related Proceedings Papers
Related Chapters
The Design and Implement of Remote Inclinometer for Power Towers Based on MXA2500G/GSM
International Conference on Mechanical and Electrical Technology, 3rd, (ICMET-China 2011), Volumes 1–3
Cavitating Structures at Inception in Turbulent Shear Flow
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Fluid Mechanics
Engineering Practice with Oilfield and Drilling Applications