Abstract
The influence of shaking spray paint cans, prior to spraying, on the characteristics of the obtained paint coatings was studied. It was found that large variations in the characteristics of sprayed paint coatings can be obtained, depending on whether the cans were shaken before the spray was applied. Therefore, care should be taken in interpretation of the results obtained in comparison of paint when spray paints are involved. To account for the obtained results, the mechanism of spraying with unshaken spray cans was studied using both X-ray radiography of spray paints during spraying and simulated experiments with sand suspensions in water.
Issue Section:
Research Papers
References
1.
Thornton
, J. I.
, “Forensic Paint Examination
,” Forensic Science Handbook
, R.
Saferstein
, Ed., Prentice-Hall
, Englewood Cliffs, NJ
, 1982
, Chapter 10, pp. 529
-571
.2.
Cousins
, D. R.
, Platoni
, C. R.
, and Russell
, L. W.
, “The Variation in the Colour of Paint on an Individual Vehicle
,” Forensic Science International
0379-0738, Vol. 24
, 1984
, pp. 197
-208
.3.
Cousins
, D. R.
, “The Use of Microspectrophotometry in the Examination of Paints
,” Forensic Science Review
, Vol. 1
, No. 2
, 1989
, pp. 141
-162
.4.
Laing
, D. K.
, Dudley
, R. J.
, Home
, J. M.
, and Isaacs
, M. D. J.
, “The Discrimination of Small Fragments of Household Gloss Paint by Microspectrophotometry
,” Forensic Science International
0379-0738, Vol. 20
, 1982
, pp. 191
-200
.5.
Nowicki
, J.
and Patten
, R.
, “Examination of U.S. Automotive Paints: I. Make and Model Determination of Hit-and-Run Vehicles by Reflectance Microspectrophotometry
,” Journal of Forensic Sciences
0022-1198, Vol. 31
, No. 2
, 04
1986
, pp. 464
-470
.6.
Springer
, E.
and Zeichner
, A.
, “The Characterization of Small Quantities of Luminescent Invisible Detection Materials Using the Docuspec TM/1 Microspectrophotometer
,” Journal of Forensic Sciences
0022-1198, Vol. 32
, No. 1
, 01
1987
, pp. 248
-253
.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.