Abstract

A technique for the estimation of time since discharge of a given class of spent shotgun shells is presented. The technique involved the use of SPME (Solid Phase Microextraction) sampling from the atmosphere inside spent shotgun shells. Compounds absorbed on the SPME fiber were desorbed and analyzed with GC-MS. The decrease in concentration of the combustion product naphthalene was monitored in all shells over a two-month period. Three conditions were examined to prevent naphthalene from escaping prior to testing the shells. A glass vial was successfully incorporated to halt the dissipation of naphthalene. At room temperature the naphthalene peak can be measured for several months and the curvefitting data can lead to an estimation of time since discharge.

Issue Section:
Technical Notes
Keywords:
forensic science, firearms, time since discharge, SPME, shotguns, firearm discharge residues, GC-MS, spent cartridges

References

1.
The Innocence Project at
Benjamin
 
N
. Cardozo School of Law is a nonprofit legal clinic founded in 1992 by
Barry
 
C
. Scheck and
Peter
 
J
. Neufeld. The Project only handles cases where post-conviction DNA testing of evidence can yield conclusive proof of innocence. The number of exonerations are as of March 13, 2003. For further information, see the Project's web site at www.innocenceproject.com.
2.
Virginia Division of Forensic Science
, March 11,
2003
. See their web site at www.dfs.state.va.us.
3.
The United States Department of Justice Fact Sheet: The President's Initiative to Advance Justice Through DNA Technology
,
11
03
2003
, pp.
1
–
2
. Also see, www.usdoj.gov.
4.
Prepared Remarks of Attorney General John Ashcroft:
DNA Initiative
,
11
03
2003
, delivered at the press
conference announcing the President's Initiative to Advance Justice Through DNA Technology
.
5.
Consortium of Forensic Science Organizations
, March, 2003.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.