This paper investigates on a gas-to-liquids (GTL) plant with ATR syngas production and proposes a new process to use a gas turbine and waste heat recovery gas/steam streams preheater to replace the fired heater. The new process features cascade utilization of fuel gas energy, as fuel gas is firstly used in a gas turbine (GT) at very high temperature and then lower-temperature GT exhaust gas is further used for preheating. Large exergy loss of heat transfer in the fired heater is eliminated. The improved process has an equivalent power generation efficiency of 80% which is significantly higher than conventional technology. Economic analysis indicates 129.8 M$ revenue would be produced over the lifetime if the extra power from a 15,000 bbl/d GTL plant can be exported to the grid at the price of cost of electricity for a conventional natural gas fired combined cycle plant.
Skip Nav Destination
Mississauga, ON L5K2R7,
Article navigation
July 2014
Research-Article
Cascade Utilization of Fuel Gas Energy in Gas-to-Liquids Plant
Rory Hynes
Mississauga, ON L5K2R7,
Rory Hynes
Hatch
,2800 Speakman Drive
,Mississauga, ON L5K2R7,
Canada
Search for other works by this author on:
Shimin Deng
Rory Hynes
Hatch
,2800 Speakman Drive
,Mississauga, ON L5K2R7,
Canada
Contributed by the Cycle Innovations Committee of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received December 8, 2013; final manuscript received January 23, 2014; published online February 20, 2014. Editor: David Wisler.
J. Eng. Gas Turbines Power. Jul 2014, 136(7): 071702 (5 pages)
Published Online: February 20, 2014
Article history
Received:
December 8, 2013
Revision Received:
January 23, 2014
Citation
Deng, S., and Hynes, R. (February 20, 2014). "Cascade Utilization of Fuel Gas Energy in Gas-to-Liquids Plant." ASME. J. Eng. Gas Turbines Power. July 2014; 136(7): 071702. https://doi.org/10.1115/1.4026599
Download citation file:
53
Views
Get Email Alerts
Cited By
Experimental Identification Of Blade Tip Rub Forces At Engine Relevant Temperatures And Speeds
J. Eng. Gas Turbines Power
Study Of Tandem Rotor Dual Wake Interaction With Downstream Stator Under Unsteady Numerical Approach
J. Eng. Gas Turbines Power
Experimental Design Validation of a Swirl-Stabilized Burner With Fluidically Variable Swirl Number
J. Eng. Gas Turbines Power (April 2025)
Experimental Characterization of a Bladeless Air Compressor
J. Eng. Gas Turbines Power (April 2025)
Related Articles
A Computational Investigation of Nonpremixed Combustion of Natural Gas Injected Into Mixture of Argon and Oxygen
J. Eng. Gas Turbines Power (August,2019)
Effect of Pressure on Combustion Characteristics in LBG-Fueled 1300°C-Class Gas Turbine
J. Eng. Gas Turbines Power (July,1994)
A Study on Low NO x Combustion in LBG-Fueled 1500°C-Class Gas Turbine
J. Eng. Gas Turbines Power (July,1996)
Comparative Performance of a Large Boiler Using Oil and Natural-Gas Fuels
Trans. ASME (January,1932)
Related Proceedings Papers
Related Chapters
Combined Cycle Power Plant
Energy and Power Generation Handbook: Established and Emerging Technologies
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Lay-Up and Start-Up Practices
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration