1-12 of 12
Keywords: water
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. May 2024, 146(5): 051021.
Paper No: GTP-23-1338
Published Online: January 12, 2024
... and molar fractions of water were obtained using thermal and electrostrictive LIGS signals. Temperatures up to 1800 K and water molar fractions between 0.01 and 0.12 were measured. A new analytic approach was developed to extract temperature from the frequencies of the measured signal within the flame brush...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Eng. Gas Turbines Power. November 2023, 145(11): 111011.
Paper No: GTP-23-1304
Published Online: September 29, 2023
... and static stiffness characteristics even working with low-viscosity liquids. This work measures static load characteristics of hydrostatic journal bearings in air (25 °C), water (from 25 °C to 70 °C), and liquid nitrogen (−197 °C). Air, water, and liquid nitrogen are used as test fluids for the test bearing...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. September 2008, 130(5): 051701.
Published Online: June 13, 2008
...Na Zhang; Noam Lior Two power plant schemes that reduce C O 2 emission and employ natural gas reforming were analyzed and discussed. The first one integrates natural gas reforming technology for efficiency improvement with an oxy-fuel combined power system (OXYF-REF), with water as the main work...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. July 2006, 128(3): 525–534.
Published Online: June 13, 2006
... and H 2 O ) into an output flow free of nitrogen and excess oxygen. The flow exiting the reduction reactor consists of water and CO 2 , the latter readily available for liquefaction, transport and long-term storage. The hot, vitiated air from the oxidation reactor is the means to produce power through...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. October 2004, 126(4): 748–754.
Published Online: November 24, 2004
...A. J. White; A. J. Meacock The injection of water droplets into compressor inlet ducting is now commonly used as a means of boosting the output from industrial gas turbines. The chief mechanisms responsible for the increase in power are the reduction in compressor work per unit flow...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. April 2004, 126(2): 334–341.
Published Online: June 7, 2004
... performance correction curves are shown together with the method of calculating mass flow rate and turbine inlet temperature from test data. A procedure for verifying guarantee data at a specific operating point is then given. Operation with water injection is then considered. Ways of correcting performance...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. July 2002, 124(3): 489–495.
Published Online: June 19, 2002
...K. Mathioudakis, Associate Professor, The effect of water injection in the combustion chamber of an industrial gas turbine is studied by means of analytic relations. Equations for the estimation of changes in the main performance parameters are provided. The relations are derived on the basis...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. July 2001, 123(3): 707–712.
Published Online: February 1, 2001
.... Nelson. 01 July 2000 01 Feb 2001 steam water thermodynamic properties enthalpy pressure specific heat entropy The advantage of the tabular Taylor series (TTSE) method is that it enables rapid calculation of thermodynamic properties without any necessary sacrifice...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. January 2000, 122(1): 150–184.
Published Online: January 1, 2000
...W. Wagner; J. R. Cooper; A. Dittmann; J. Kijima; H.-J. Kretzschmar; A. Kruse; R. Maresˇ; K. Oguchi; H. Sato; I. Sto¨cker; O. Sˇifner; Y. Takaishi; I. Tanishita; J. Tru¨benbach; Th. Willkommen In 1997, the International Association for the Properties of Water and Steam (IAPWS) adopted a new...