Over time, thermally protected and thermally insulated rail tank-cars may develop insulation deficiencies due to the continuous motion and vibrations. These deficiencies are generally not visible due to the protective outer steel jacket. A research program was undertaken to develop an inspection procedure to identify deficiencies in the thermal insulation. Thermography was selected as the most effective means of inspecting the thermal insulation because it is nondestructive, noncontact, and economical. Thermography takes advantage of the fact that when a temperature difference exits between the contents of the tank car and the ambient conditions, the presence of insulation deficiencies generates temperature gradients on the surface of the tank-car’s outer steel jacket that can then be identified using a thermal imager. A series of laboratory and field tests were conducted to determine under what ambient and tank conditions the inspection procedure is effective. Using a low-cost, uncooled, 8–12-μm waveband thermal imager, it was found that the imager could detect insulation deficiencies under temperature gradient conditions compatible with typical day-night cycle temperature variations. Field tests proved the technique to be practical and also showed that solar heating enhances the inspection procedure under certain conditions. This paper presents the results of the laboratory tests and shows some preliminary field test results. [S0094-9930(00)01104-5]
Skip Nav Destination
e-mail: birk@me.queensu.ca
e-mail: cunningh@me.queensu.ca
Article navigation
November 2000
Technical Papers
Thermographic Inspection of Rail-Car Thermal Insulation
A. M. Birk,
e-mail: birk@me.queensu.ca
A. M. Birk
Mechanical Engineering, Queen’s University, Kingston, Ontario, K7K 3N6, Canada
Search for other works by this author on:
Mark. H. Cunningham
e-mail: cunningh@me.queensu.ca
Mark. H. Cunningham
Mechanical Engineering, Queen’s University, Kingston, Ontario, K7K 3N6, Canada
Search for other works by this author on:
A. M. Birk
Mechanical Engineering, Queen’s University, Kingston, Ontario, K7K 3N6, Canada
e-mail: birk@me.queensu.ca
Mark. H. Cunningham
Mechanical Engineering, Queen’s University, Kingston, Ontario, K7K 3N6, Canada
e-mail: cunningh@me.queensu.ca
Contributed by the Pressure Vessels and Piping Division and presented at the Pressure Vessels and Piping Conference, San Diego, California, July 26–30, 1998, of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS. Manuscript received by the PVP Division, February 15, 2000; revised manuscript received July 6, 2000. Associate Technical Editor: J. C. Duke, Jr.
J. Pressure Vessel Technol. Nov 2000, 122(4): 494-501 (8 pages)
Published Online: July 6, 2000
Article history
Received:
February 15, 2000
Revised:
July 6, 2000
Citation
Birk, A. M., and Cunningham, M. H. (July 6, 2000). "Thermographic Inspection of Rail-Car Thermal Insulation ." ASME. J. Pressure Vessel Technol. November 2000; 122(4): 494–501. https://doi.org/10.1115/1.1310365
Download citation file:
Get Email Alerts
Cited By
Measurement of Steam-Generator-Tube Vibration Damping Caused by Anti-Vibration-Bar Supports
J. Pressure Vessel Technol (February 2025)
Surface Strain Measurement for Non-Intrusive Internal Pressure Evaluation of a Cannon
J. Pressure Vessel Technol (December 2024)
Dynamic Response and Damage Analysis of a Large Steel Tank Impacted by an Explosive Fragment
J. Pressure Vessel Technol (February 2025)
Related Articles
Special Issue on the Nondestructive Evaluation of Pipeline and Vessel Structures
J. Pressure Vessel Technol (August,2005)
Ray Based Model for the Ultrasonic Time-of-Flight Diffraction Simulation of Thin Walled Structure Inspection
J. Pressure Vessel Technol (August,2005)
The Use of Risk-Based Approaches in Post-Construction Standards
J. Pressure Vessel Technol (August,2000)
PVRC Division on Continued Operation of Equipment
J. Pressure Vessel Technol (February,2000)
Related Proceedings Papers
Related Chapters
Inspection and Maintenance of Ageing Concrete Oil and Gas Structures on the Norwegian Continental Shelf
Ageing and Life Extension of Offshore Facilities
Optimizing the Inspection of Corrosion Under Insulation in Badak LNG Plant by the Implementation of Risk-Based Method
Asset Integrity Management of Critical Infrastructure
Development of Nuclear Boiler and Pressure Vessels in Taiwan
Companion Guide to the ASME Boiler and Pressure Vessel Code, Volume 3, Third Edition