A method is proposed to calculate Flexibility Factors for molded and mitered 90 deg polyethylene elbows for both in-plane and out-of-plane loading based on Code Case N-319-3, January 17, 2000. Displacement measurements in the direction of the applied forces were made during the testing of each elbow in addition to measuring the applied forces. By making use of Code Case equations, Flexibility Factors can be directly developed. Appendices to the paper show how these factors can be added to the deformation and rotation equation from curved Euler beam theory. One of the basic assumptions used in the Code Case and in this derivation is that there is no ovalization from torsion. Thus, the Flexibility Factor for the torsional displacement (twisting) of an elbow is one. Results show that an exact solution for Flexibility Factors based on the definition in Section III of the ASME Boiler and Pressure Vessel Code can be obtained for in-plane loading. However, for out-of-plane loading, the Flexibility Factors are geometry dependent if the values are based on measured elbow deflections. The difference is associated with the contributions of both torsion and bending to elbow deflections.
Skip Nav Destination
e-mail: Rscrud@aol.com
Article navigation
April 2012
Research Papers
Flexibility Factors for High Density Polyethylene Elbows
Rudolph J. Scavuzzo,
e-mail: Rscrud@aol.com
Rudolph J. Scavuzzo
Professor of Mechanical Engineering Emeritus, The University of Akron
, Akron, OH
Search for other works by this author on:
Siegrid Hall
Siegrid Hall
Search for other works by this author on:
Rudolph J. Scavuzzo
Professor of Mechanical Engineering Emeritus, The University of Akron
, Akron, OHe-mail: Rscrud@aol.com
Charles N. Papadelis
Siegrid Hall
J. Pressure Vessel Technol. Apr 2012, 134(2): 021209 (7 pages)
Published Online: January 19, 2012
Article history
Received:
September 8, 2010
Revised:
February 14, 2011
Online:
January 19, 2012
Published:
January 19, 2012
Citation
Scavuzzo, R. J., Papadelis, C. N., and Hall, S. (January 19, 2012). "Flexibility Factors for High Density Polyethylene Elbows." ASME. J. Pressure Vessel Technol. April 2012; 134(2): 021209. https://doi.org/10.1115/1.4004616
Download citation file:
48
Views
Get Email Alerts
Cited By
The Behaviour of Elbow Elements at Pure Bending Applications Compared to Beam and Shell Element models
J. Pressure Vessel Technol
Measurement of Steam-Generator-Tube Vibration Damping Caused by Anti-Vibration-Bar Supports
J. Pressure Vessel Technol (February 2025)
Related Articles
On the Effectiveness of Higher-Order Terms in Refined Beam Theories
J. Appl. Mech (March,2011)
Correlation of Patellar Tracking Pattern With Trochlear and Retropatellar Surface Topographies
J Biomech Eng (December,2000)
Response Measurement Accuracy for Off-Resonance Excitation in Atomic Force Microscopy
J. Dyn. Sys., Meas., Control (January,2012)
The Effect of D/T on the Load Interaction Behavior of a Plain Pipe
J. Pressure Vessel Technol (November,2004)
Related Proceedings Papers
Related Chapters
Flexibility Analysis
Process Piping: The Complete Guide to ASME B31.3, Third Edition
Achievements, Challenges, and Opportunities
Computer Vision for Structural Dynamics and Health Monitoring
Basic Concepts
Design & Analysis of ASME Boiler and Pressure Vessel Components in the Creep Range