Steady heat transfer by natural convection and conduction is numerically studied in passive solar collector systems consisting of a massive wall with honeycomb structure and without vents. The boundary conditions are constant heat flux on the wall and fins, isothermal on the vertical bounding sides, and adiabatic on the horizontal sides. The governing parameters are the Rayleigh number (106 ≤ Ra ≤ 5 × 109), the aspect ratio of the enclosures (0.4 ≤ A = H′/L′ ≤ 1.4), the dimensionless lengths of the fins (0 ≤ B = l′/Ll′ ≤ 1), the aspect ratio of the microcavities (0.05 ≤ C = h′/L′ ≤ 1), the wall thickness (0.008 ≤ w = w′/L′ ≤ 0.033). The fin thickness (e = e′/H′ = 0.06) and the Prandtl number (Pr = 0.72) were constant, and the conductivity ratio was variable (10−4 ≤ kr ≤ 5 × 106). Local and average Nusselt numbers along the long sides are calculated as a function of various parameters. Streamlines and isotherms are produced. Effects of various parameters on the heat transfer are examined and heat transfer correlations are derived.

Issue Section:
Research Papers
Topics:
Heat conduction, Honeycomb structures, Natural convection, Solar collectors, Vents, Heat transfer, Fins, Boundary-value problems, Electrical conductivity, Heat flux, Prandtl number, Rayleigh number, Thermal conductivity, Wall thickness
1.
Baer, S., 1976, “Movable insulation,” Passive Heating and Cooling Proc., May 18–19, Albuquerque, NM, pp. 70–72.
2.
Ben Yedder
R.
, and
Bilgen
E.
,
1990
, “
Numerical Study of Laminar Natural Convection in Composite Trombe Wall Systems
,”
Solar & Wind Technology
, Vol.
7
, No.
6
, pp.
675
–
683
.
3.
Ben Yedder
R.
, and
Bilgen
E.
,
1991
, “
Natural Convection and Conduction in Trombe Wall Systems
,”
Int. J. Heat Mass Transfer
, Vol.
34
, pp.
1237
–
1248
.
4.
Catton, I., 1978, “Natural Convection in Enclosures,” Proc. Sixth Int. Heat Transfer Conf., Vol. 6, pp. 13–31.
5.
De Vahl Davis
G.
, and
Jones
I. P.
,
1983
, “
Natural Convection in a Square Cavity: A Comparison Exercise
,”
Int. J. Num. Meth. Fluids
, Vol.
3
, pp.
227
–
248
.
6.
Gebhart, B., Jaluria, Y., Mahajan, R. P., and Sammakia, B., 1988, Buoyancy-Induced Flows and Transport, Hemisphere, New York.
7.
Hasnaoui
M.
,
Vasseur
P.
, and
Bilgen
E.
,
1992
, “
Natural Convection in Retangular Enclosures with Adiabatic Fins Attached on the Heated Wall
,”
Warme und Stoffubertragung
, Vol.
27
, pp.
357
–
368
.
8.
Hasnaoui, M., Vasseur, P., and Bilgen, E., 1990, “Natural Convection in Rectangular Enclosures with Fins Attached to One of the Isothermal Walls,” J. T. Beard and M. A. Ebadian, eds., ASME Solar Engineering, pp. 131–137.
9.
Hasnaoui
M.
,
Zrikem
Z.
,
Vasseur
P.
, and
Bilgen
E.
,
1990
, “
Radiation Induced Natural Convection in Enclosures with Conducting Walls
,”
Solar & Wind Technology
, Vol.
7
, pp.
5151
–
5125
.
10.
Le Breton
P.
,
Caltagirone
J. P.
, and
Arquis
E.
,
1991
, “
Natural Convection in a Square Cavity with Thin Porous Layers on It’s Vertical Walls
,”
J. Heat Transfer
, Vol.
113
, pp.
892
–
898
.
11.
Mbaye
M.
, and
Bilgen
E.
,
1992
, “
Natural Convection in Porous Wall, Solar Collector Systems without Vents
,”
Trans. ASME
, Vol.
114
, pp.
40
–
46
.
12.
Patankar, S. V., 1980, Numerical Heat Transfer and Fluid Flow, Hemisphere, Washington D.C.
13.
Scozia
R.
, and
Frederick
R. L.
,
1991
, “
Natural Convection in Slender Cavities with Multiple Fins Attached to an Active Wall
,”
Num. Heat Transfer
, Vol.
20
, Part A, pp.
127
–
158
.
14.
Zrikem
Z.
, and
Bilgen
E.
,
1986
, “
Theoretical Study of a Non-Convective Trombe Wall Collector with Honeycomb Structure
,”
Solar & Wind Technology
, Vol.
3
, No,
1
, pp.
33
–
44
.
This content is only available via PDF.
Copyright © 1995
 by The American Society of Mechanical Engineers
You do not currently have access to this content.