This research is intended to design and manufacture a multilayer solar distiller at a promising cost. The solar distiller manufactured has the same design as simple water distillers, which are based on the principle of evaporation and condensation with a different energy cycle, where the processes of evaporation and condensation are completely isolated. The obtained results showed that the amount of produced water has increased by 60% compared to the traditional solar distillers, where the system is not isolated. No catalysts were used, and the areas of the evaporation and condensation have also been increased leading to the production of distilled water under natural conditions and low cost. A comparison between the theoretical and experimental results is performed. The productivity was as follows: 8.45, 11.04, 12.20, 21.44, 18.69, 16.15, and 14.49 L/day in January, February, March, September, October, November, and December, respectively.
Skip Nav Destination
Article navigation
August 2018
Research-Article
Design and Fabrication of a Multistage Solar Still With Three Focal Concentric Collectors
Fayadh M. Abed
Fayadh M. Abed
College of Engineering,
Tikrit University,
SalahAdeen-Tikrit,
Al-Qadysia 34001, Iraq
e-mail: Fayadh_mohamed@tu.edu.iq
Tikrit University,
SalahAdeen-Tikrit,
Al-Qadysia 34001, Iraq
e-mail: Fayadh_mohamed@tu.edu.iq
Search for other works by this author on:
Fayadh M. Abed
College of Engineering,
Tikrit University,
SalahAdeen-Tikrit,
Al-Qadysia 34001, Iraq
e-mail: Fayadh_mohamed@tu.edu.iq
Tikrit University,
SalahAdeen-Tikrit,
Al-Qadysia 34001, Iraq
e-mail: Fayadh_mohamed@tu.edu.iq
1Corresponding author.
Contributed by the Solar Energy Division of ASME for publication in the JOURNAL OF SOLAR ENERGY ENGINEERING: INCLUDING WIND ENERGY AND BUILDING ENERGY CONSERVATION. Manuscript received November 3, 2017; final manuscript received February 4, 2018; published online March 13, 2018. Assoc. Editor: Gerardo Diaz.
J. Sol. Energy Eng. Aug 2018, 140(4): 041003 (9 pages)
Published Online: March 13, 2018
Article history
Received:
November 3, 2017
Revised:
February 4, 2018
Citation
Abed, F. M. (March 13, 2018). "Design and Fabrication of a Multistage Solar Still With Three Focal Concentric Collectors." ASME. J. Sol. Energy Eng. August 2018; 140(4): 041003. https://doi.org/10.1115/1.4039351
Download citation file:
Get Email Alerts
Thermodynamic power cycle for the solar vortex engine
J. Sol. Energy Eng
Using Image Analysis Techniques for Dust Detection Over Photovoltaic Panels
J. Sol. Energy Eng (August 2025)
Solar Simulator Prototype With Halogen and Light-Emitting Diode Sources
J. Sol. Energy Eng (August 2025)
Experimental Study of a Cooling Photovoltaic Solar Panel Using Water-Wet Jute Fabric
J. Sol. Energy Eng (August 2025)
Related Articles
Theoretical and Experimental Investigation of a Novel Multistage Evacuated Solar Still
J. Sol. Energy Eng (August,2005)
Sustainable Agriculture Irrigation System Using a Novel Solar Still Design With a Compound Parabolic Concentrator Reflector
J. Sol. Energy Eng (June,2020)
Experimental Study of Single-Slope Solar Still Coupled With Nanofluid-Based Volumetric Absorption Solar Collector
J. Sol. Energy Eng (February,2022)
A Feasibility Study of the Use of Solar Photovoltaic Energy in Saudi Arabia: A Case Study Assessment in a Factory in Zulfi City
J. Sol. Energy Eng (August,2018)
Related Proceedings Papers
Related Chapters
Energy Balance for a Swimming Pool
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Integration of Solar Energy Systems
Handbook of Integrated and Sustainable Buildings Equipment and Systems, Volume I: Energy Systems
Future Solar Energy Applications
Solar Energy Applications