...@futo.edu.ng Email: cadamadu@futo.edu.ng Contributed by the Solar Energy Division of ASME for publication in the J ournal of S olar E nergy E ngineering : I ncluding W ind E nergy and B uilding E nergy C onservation . 22 05 2023 23 09 2023 23 09 2023 03 11 2023...

... Energy Division of ASME for publication in the J ournal of S olar E nergy E ngineering : I ncluding W ind E nergy and B uilding E nergy C onservation . 24 03 2023 21 09 2023 23 09 2023 31 10 2023 nanofluid particles deposition multiphase heat transfer sticking...

... coefficient is compared to that obtained for a traditional circular-shaped tube. Moreover, the energy balance model is adapted to simulate the thermal efficiency of the considered tubes as a function of the deviation angle with some assumptions. The obtained results prove that from a deviation angle value...

... Contributed by the Solar Energy Division of ASME for publication in the J ournal of S olar E nergy E ngineering . 07 04 2023 13 10 2023 15 10 2023 20 10 2023 absorber collector Efficiency Energy fluid flow heating renewable simulation solar Accepted Manuscript...

... to conventional frames. The results are promising for the use of the new PV frame designs for distributed manufacturing targeted at specific applications. Email: ssadat6@uwo.ca Email: nvandew@uwo.ca 1 Corresponding author. Email: joshua.pearce@uwo.ca Contributed by the Solar Energy Division...

... Contributed by the Solar Energy Division of ASME for publication in the J ournal of S olar E nergy E ngineering : I ncluding W ind E nergy and B uilding E nergy C onservation . 04 07 2023 15 09 2023 16 09 2023 13 10 2023 solar air heater (collector) finned absorber...

...Fei Lai; Dan Wu; Jinzhi Zhou; Yanping Yuan There has been an increasing interest in solar-driven combined energy supply systems for low-temperate applications, particularly those based on the Organic Rankine Cycle (ORC), Kalina Cycle (KC), or Trilateral Cycle (TLC). However, systems based...

..., this system is integrated with a cold thermal energy storage system. The procedure described here will be applied to a combined cooling and power system with a thermal energy storage capability for a large medical center in Jeddah, Saudi Arabia. Through an exergoeconomic analysis of the integrated system...

... with an H 2 O–LiBr absorption system to simultaneously satisfy both a refrigeration load and an air-conditioning load. Results of this analysis shows that the CAC system uses 7.1% less thermal energy than the sum of the energies used by the ammonia absorption system and the LiBr absorption system...

... agricultural products within an acceptable period based on the previous studies and therefore, the drying system is recommended to avoid the shortcomings associated with traditional/open sun drying. Email: cakomolafe@umat.edu.gh Contributed by the Solar Energy Division of ASME for publication...

... or multigeneration systems. Employing the subsystems forming any multigeneration system as a reference, the relative saving ratios of energy and exergy are calculated. These saving ratios are used as metrics for the goodness of multigeneration systems. We will also use them to calculate equivalent energetic...

...Gopal Nath Tiwari; Rohit Kumar Singh; Akhoury Sudhir Kumar Sinha; Amit Kumar Singh The opaque photovoltaic thermal (PVT) produces both thermal and electrical energy. In order to increase thermal energy, we have considered flexible (Al-based) photovoltaic (PV) module for the present study. Further...

.... Email: metida_siritan@elearning.cmu.ac.th 1 Corresponding author. Email: vafai@engr.ucr.edu Email: niti@eng.cmu.ac.th Email: pradit@eng.cmu.ac.th Email: phrut@eng.cmu.ac.th Contributed by the Solar Energy Division of ASME for publication in the J ournal of S olar E nergy E...

.... 1 Corresponding author. Email: jdortega4@unm.edu Email: ckho@sandia.gov Email: guilleanaya@unm.edu Email: kalmoth@unm.edu Email: gowtham@unm.edu Contributed by the Solar Energy Division of ASME for publication in the J ournal of S olar E nergy E ngineering : I ncluding W...

..., and the lowest average Nusselt number is observed at a base angle of 45 deg, i.e., triangular duct, for all the Reynolds numbers considered in the study. Here, k and ɛ represent turbulent kinetic energy and turbulent dissipation rate, respectively. The transport equations for this RNG k – ɛ turbulence...

... such as particle size distribution, particle morphology, and particle radiative properties. The authors thank Matthew Bauer and Andru Prescod from DOE for their management and support of this work, which was funded by DOE’s Solar Energy Technologies Office (Award No. 33869). Sandia National Laboratories...

... in Parabolic Trough Solar Power Technology ,” ASME J. Sol. Energy Eng. , 124 ( 2 ), pp. 109 – 125 . 10.1115/1.1467922 [2] Praveen , R. , Abdul Baseer , M. , Awan , A. B. , and Zubair , M. , 2018 , “ Performance Analysis and Optimization of a Parabolic Trough Solar Power Plant...

... and Scattering Mode on the Optimal Solar Absorbing Nanofluid ,” ASME 2009 3rd International Conference on Energy Sustainability, Volume 1 , San Francisco, CA , Jan. , pp. 791 – 796 . [44] Malkiel , I. , Mrejen , M. , Nagler , A. , Arieli , U. , Wolf , L. , and Suchowski , H...

..., and energy. The governing equations are solved using the SST k–ω model. Thermo-hydraulic performance parameter (THPP) is also calculated using N u a v g _ r and f a v g _ r , which further helped to determine the optimal arrangement of inverted T-shaped ribs on the absorber plate of the SAH. The maximum THPP...

... , Boca Raton, FL . [2] Prasad , B. N. , and Saini , J. S. , 1988 , “ Effect of Artificial Roughness on Heat Transfer and Friction Factor in a Solar Air Heater ,” Sol. Energy , 41 ( 6 ), pp. 555 – 560 . 10.1016/0038-092X(88)90058-8 [3] Kumar , D. , Choudhury , R...