...Kashinath Barik; B. Swain; A.R. Pati; Susmit Chitransh; S.S. Mohapatra In the current investigation, by using a very low mass flux co-axial laminar multiphase fluid jet, enhancement in heat transfer rate, uniformity in heat flux distribution, and reduction in coolant consumption rate...

..., length-to-nominal diameter of 4.3, and an injection angle of 30°. In this study, the authors will also take into account the heat transfer into the coolant flow from the coolant channel. In other words, the coolant temperature at the exit of the coolant hole will be different than that measured...

..., the maximum evaporator heat flux carried by the coolant without dryout was found to be 52% higher than the value for the same heat pipe using pure water as a coolant under comparable conditions. Peak evaporator heat flux values above 100 W/cm 2 were achieved with some mixtures. Evaporator and condenser heat...

...L. W. Jin; K. C. Leong; I. Pranoto; H. Y. Li; J. C. Chai This paper presents an experimental study of heat transfer in a pool boiling evaporator with porous insert. Porous graphite foams were structured into cubic block and straight fin shapes and tested with FC-72 and HFE-7000 coolants...

... and cooling water (coolant) temperatures. The results clearly indicate that for the same cooling capacity of the chiller and compared with the performance at the design point value, increasing the inlet driving hot water temperature results in an increase in the required absorber size and consequently...

...Anilchandra Attaluri; Zhongping Huang; Liang Zhu In this study, we build and test a prototype of an interstitial cooling device in a tissue-equivalent gel phantom mimicking the human neck. The effectiveness of the device is measured by the capability of delivering a coolant temperature of lower...